StewMac Pickguard Shielding Plate for Strat

StewMac Pickguard Shielding Plate for Strat

Aluminum pickguard shielding for Strat will minimize that annoying ground buzz. This is pre-cut, so you can avoid the hassle of cutting your own shapes, however reshaping is possible with a sharp pair of scissors. 

Note: Aluminum shielding will not accept solder. Use our Conductive Copper Tape for shielding jobs where solder connections are required.

Tip: For more complete shielding, line your pickup and control cavities with self-adhesive Conductive Copper Tape, or several coats of brush-on Conductive Shielding Paint. Extend a bit of the tape or paint outside each cavity and onto the top of the guitar to make contact with your fully shielded pickguard. The control pots installed on the pickguard are the electrical ground connection for the shielding.